AIRCRAFT OUT OF CONTROL IN CROSS WIND...

Comments

Post a Comment

Popular posts from this blog

EASA : Module17 Propeller Question - Answer

Image
EASA : Module17 Propeller Question - Answer On which type of turbo-propeller would you expect to find a parking brake a) compounded twin spool b) free turbine c) direct coupled twin spool Ans:b * Propeller blade angle a) increases from root to tip b) decreases from root to tip c) is constant along the blade length Ans:b * The purpose of the pitch change cams is to a) convert linear motion to rotary motion. b) convert rotary motion to linear motion. c) prevent windmilling Ans:a * What does the torque meter reading indicate in a gas turbine engine? a) Torque reaction at the reduction gear b)  Engine torque c) The ratio between engine thrust and engine torque Ans:a * The gear type pump in a C.S.U. or P.C.U a) lubricates the entire propeller system b)  boosts engine oil system pressure c) assist the governor valve to move Ans:b * The gear segments on the blade roots of a hydromatic propeller mesh with the a) stationary cam b)  torque tubes and eye bolts c) movin
Read more

Aircraft Landing Gear

Image
Why do aircraft have only three landing gear? Why not four? Most aircraft today have three landing gear. Two main landing gear struts located near the middle of the aircraft usually support about 90% of the plane's weight while a smaller nose strut supports the rest. This layout is most often referred to as the "tricycle" landing gear arrangement. However, there are numerous other designs that have also been used over the years, and each has its own advantages and disadvantages. Let's take a closer look at the various undercarriage options available to engineers. Tail-wheel or Tail-dragger :  Gear Though the tricycle arrangement may be most popular today, that was not always the case. The tail-wheel undercarriage dominated aircraft design for the first four decades of flight and is still widely used on many small piston-engine planes. The tail-dragger arrangement consists of two main gear units located near the center of gravity (CG) that support the majority of the p
Read more

Adverse yaw!!! Roll causes Yaw and Yaw causes Roll...

Image
Do you know what adverse yaw is and how to solve it? To understand what adverse yaw is, we need to first explain the axes of motion for an  airplane. An aircraft in flight can rotate around three different axes, as illustrated below. Aircraft control surfaces However, the effect of one control surface is not always limited to just pitch, roll, or yaw  alone. When the deflection of one control surface affects more than one of these  orientations, we say that the orientations are coupled. The most important of these  coupled interactions is adverse yaw. To better understand the concept, let's study a  picture of what happens when the pilot deflects the ailerons to roll the aircraft. As you can see, the aircraft rolls because one aileron is deflected downward while the other is deflected upward. Lift increases on the wing with the downward-deflected aileron because the deflection effectively increases the camber of that portion of the wing. Conversely, lift decreases on the wing with
Read more